ESP filters 4,000–64,000 m³/h · CE certified · ISO 9001 · Shipping to 80+ countries

info@souniny.com / WhatsApp +86 189 2910 1713

Guide · Comparison

ESP filter, baffle filter, carbon: which stage does what

These three are not competing products. They remove different things, and a kitchen usually needs two of them. The confusion costs money in both directions — over-specifying a stage that does nothing, and expecting one stage to do all three jobs.

Short answer. A baffle filter in the hood catches coarse grease and stops it reaching anything else — it is cheap, and it is not a substitute for anything. An ESP filter removes the fine smoke and grease aerosol the baffle misses, at 95–98%. Activated carbon removes odour, and only odour — it belongs after the ESP, never instead of it.

The three stages are sequential, not alternative. Grease and smoke are particles of different sizes; odour is a gas. A baffle removes droplets by impingement, an ESP removes sub-micron particles by electrostatic attraction, and carbon adsorbs odorant molecules onto a vast internal surface. Trying to remove particles with carbon wastes the carbon; trying to remove odour with an ESP does nothing at all.

Four-stage filtration diagram showing equalising screen, ionisation zone, collection plates and final screen
The ESP stage in detail. The equalising screen is doing the job a baffle does in the hood, in a smaller space.

What each one actually removes

 BaffleESPCarbon
Coarse grease dropletsYes, 40–70%YesNo — it would blind the bed
Fine oil aerosolPoor95–98%No
Sub-micron smokeVery poorHighNo
Odour moleculesNoNoYes, ~90% with adequate dwell
Pressure dropRises as it loads107–176 Pa, flatRises as it loads
ConsumableReplacement meshNoneReplacement carbon

The baffle: a cheap stage that earns its place

A baffle filter is a set of angled steel blades in the hood. Air turns twice between them; grease droplets cannot turn that sharply and hit the metal instead. It is crude, it is effective on the coarse fraction, and it costs almost nothing to buy or clean.

Its real job on a kitchen with an ESP is protection. Everything a baffle catches is grease that never reaches the cell, which extends the interval between washes — and the wash interval is the variable that decides whether an ESP performs to specification over its life. A kitchen that removes its baffles "because the ESP handles it" is shortening the life of a much more expensive component to save five minutes a week.

The ESP: the only stage that touches smoke

What a baffle misses — and it misses most of the mass that is actually visible as a plume — is aerosol in the 0.1 to 10 micrometre range. That is the fraction that carries the smoke, travels furthest, deposits on the neighbour's window and is measured by whatever the local authority uses to test the discharge.

Removing it is what an electrostatic precipitator does, and it does so without a consumable in the gas path: charge the particle at 12 kV, collect it on earthed plates 7.5 mm apart, wash the plates. The pressure drop stays near-constant at 107–176 Pa across the whole range, because nothing is being progressively blinded.

What an ESP does not do is remove odour. This surprises people, because 95% of the smoke disappearing is such a visible improvement that the remaining smell is more noticeable, not less. The smoke was carrying the eye; the odour is what is left when the smoke is gone.

The carbon: last, and only if needed

Activated carbon adsorbs. Its capacity is finite and it is consumed by everything it adsorbs, which is why it must sit behind the ESP rather than in front of it — carbon that is asked to handle grease will be saturated with grease within weeks and will then remove nothing.

The KL-D-W odour removal box is built around that constraint: a front-access stack of carbon panels after the ESP stage, rated at around 90% odour removal on the gas that reaches it. Not 90% of the original exhaust odour — 90% of what survives the cell.

Carbon is the right answer where the condition is about smell at a receptor: a residential neighbour, a hotel guest floor, a terrace, a school. It is money spent for nothing where the limit is a mass concentration at the stack, because the ESP already meets that on its own.

The order is not negotiable

Hood baffle → water spray (solid fuel only) → ESP → carbon → fan → discharge. Each stage is positioned to protect the one after it, and every deviation costs either performance or money.

  • Carbon before the ESP: saturated in weeks by grease the cell would have removed for free.
  • ESP before the baffle: the cell becomes the grease trap, and the wash interval collapses.
  • ESP on raw charcoal smoke with no water stage: sparks puncture the cell, ash bridges the plates.
  • Fan before the ESP: the fan becomes a grease-coated, unbalanced, noisy problem, and the cell runs pressurised, leaking fumes into the plant room.

That last one is the most common installation error we see. The cell must sit upstream of the fan, on the negative-pressure side, so that any leak in the cabinet pulls air in rather than pushing grease out.

What this means for a quotation

If someone quotes you a single box and tells you it handles grease, smoke and smell, ask which of the three mechanisms it uses. There is no single passive device that does all three well, and the quotes that claim otherwise are usually a baffle with a carbon pad — effective for a few weeks, then a maintenance liability.

Conversely, if a quotation includes a carbon stage and your only condition is a visible-emissions limit, you are paying for something the permit does not ask for. Send us the permit wording and we will tell you which stages you actually need — including the ones we would rather not sell you.

Next step

Send the layout. We will confirm the model.

Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.

Size it in 30 seconds Chat on WhatsApp

Typical reply within one working day · MOQ 1 unit