Note · Technology
Dry electrostatic precipitator: right for ash, wrong for grease
Every technology article on precipitators describes rapping as if it were universal. It is not: it is a property of dry dust, and it is the reason the industrial precipitator and the kitchen cabinet are different machines.
Short answer. A dry precipitator collects dust on plates and removes it by mechanical rapping into a hopper, with no water. It suits fly ash and mineral dust; on sticky or liquid catch such as cooking grease it smears, carbonises and bridges the plate gap.
The design logic is simple: if what you collect is a powder, you can knock it off. Add a hammer on a timer, a hopper underneath, and a rotary valve. No water, no effluent, no corrosion, and the collected material is often saleable.
Where dry wins
Fly ash from coal or biomass boilers, cement kiln dust, metal oxide fume from smelting, wood dust in some configurations. All of them are free-flowing solids at operating temperature, and all of them release from a plate when it is struck.
Dry units also run hot, often above the acid dew point, which avoids the corrosion that makes wet designs expensive in the wrong gas.
Where dry fails
Cooking grease is liquid at cabinet temperature. Rapping a greasy plate does nothing except redistribute the film. Over a few weeks the film thickens, the effective gap closes, the supply derates and the unit begins to arc — and the collected material has become a fuel load inside a hot duct.
The same is true of oil mist from machining and of tar fume. Anything that is sticky at operating temperature needs liquid removal, not mechanical removal.
What a kitchen does instead
The kitchen cabinet is, in effect, a wet precipitator run in batches. A sloped sump collects the film, a drain takes it to a grease trap, and the cell is washed on a schedule — manually every 7–30 days depending on the cooking, or automatically on a 1–15 day cycle in the self-cleaning version.
The trade is water handling for reliability. A dry unit needs no drain; a kitchen unit is useless without one. If a site cannot get a drain to the cabinet position, that constraint shapes the whole design, and it is better known before the drawing than after.
Both architectures are in the catalogue, but the ESP filter range for kitchens is uniformly the wet-wash type — the dry industrial design is quoted only for genuine dust applications.
Everything described here is what gets built into a kitchen ESP before it leaves the factory — the cell, the drain, the interlock, the fan curve.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
