ESP filters 4,000–64,000 m³/h · CE certified · ISO 9001 · Shipping to 80+ countries

info@souniny.com / WhatsApp +86 189 2910 1713

Electrostatic precipitators · 4,000–64,000 m³/h

The ESP filter that makes a kitchen exhaust invisible

Plate-type electrostatic precipitators for commercial kitchen exhaust: 95%+ removal, 1–2 mg/m³ at the outlet, and a stainless cell you wash instead of replace. Thirteen models, sized by the cooking load rather than the room.

  • 4,000–64,000m³/h across 13 models
  • 95%+grease & smoke removal
  • 1–2 mg/m³at the outlet
  • 7.5 mmplate spacing, 12 kV
KL-D-J320 electrostatic precipitator — double-stack cabinet, 32,000 m³/h
CE · LVD + EMC ISO 9001:2015
KL-D-J320 32,000 m³/h · double-stack cabinet · 1,200 W

Certified and shipping to

CE — LVD 2014/35/EU + EMC 2014/30/EU 50+ granted patents ISO 9001:2015 80+ export markets

The range

Seven ways to take grease, smoke and smell out of the exhaust

The ESP cell is the core of every one of them. What changes is where it sits and what happens either side of it — water ahead of the cell for charcoal, carbon behind it for odour, a wash arm inside it for sites that cannot keep a cleaning rota.

Compare the series

Sizing tool

Most undersized ESP filters were never calculated — they were guessed

Airflow comes from the cooking load, not the floor area. Pressure comes from the duct, not the fan label. The calculator does both in one pass and tells you which KL-D-J model covers the result, in m³/h and CFM.

  • Cooking type sets the multiplier — ×0.80 for steam, ×1.50 for charcoal
  • Burner count or hood length, whichever your drawing shows
  • Duct length, 90° and 45° bends converted to equivalent metres
  • System pressure in Pa and in. wg, plus the duct diameter at 8 m/s
Four-stage filtration diagram: pre-filter, charging, collection and discharge

Four stages, one pass: equalising screen, 12 kV charging zone, low-voltage collection plates, final screen. Grease runs down the plates to a drain instead of up the duct.

Electrostatic precipitator cabinet mounted on a stainless frame in a commercial kitchen

A KL-D-J cabinet sits in the duct run, upstream of the fan, on the negative-pressure side.

How it works

Ionise, collect, drain. No consumable in the gas path.

Dirty air passes an equalising screen that takes out the coarse oil mist. What remains is charged at 12 kV in the ionisation zone, then captured on earthed plates in the collection zone. Purified air leaves at 1–2 mg/m³ — low enough that the roof discharge is invisible.

The collected grease runs down the stainless plates and gathers at a bottom drain, where it is emptied in one place instead of being carried up the duct and onto the roof.

  • Two zones in a single pull-out cell — charging does not disturb collection
  • 7.5 mm plate spacing held within 0.8 mm across the cell
  • Constant-voltage supply tracks the load, so efficiency does not fade between washes
  • Eight protection layers, door-open cut-out, IP65 electrical section

Why these units hold their efficiency

The cell is the product. Everything else protects it.

An electrostatic precipitator is not a filter that clogs; it is a field that collects. Efficiency is decided by plate geometry, by how well the supply holds voltage as grease builds, and by whether anyone washes the cell on schedule. Those three things are what the design is spent on.

Geometry you can measure

7.5 mm spacing, held within 0.8 mm, over a 195 mm adsorption width on 0.8 mm stainless plates formed in twelve passes. Tolerance is the difference between a cell that collects and one that arcs.

Voltage that follows the load

Constant-voltage control tracks the cell as grease accumulates, so the last week before a wash performs like the first. Eight protection layers keep it there without tripping.

A wash interval that actually happens

Either the display prompts you, or the cabinet washes itself on a 1–15 day cycle. Both exist because the same failure — a cell nobody washed — causes most failed inspections.

Souniny at a glance

Founded
2015, Shenzhen
Factory
8,000 m², Dongguan
Export markets
80+
Models in range
200+
Patents
50+ granted
Certification
CE · ISO 9001

Send the appliance list and the duct route and we will return a model, an airflow figure and a drawing. OEM and ODM builds are normal work here.

Questions we get before an order

ESP filters, answered plainly

What is an electrostatic precipitator (ESP)?

An electrostatic precipitator is an air-cleaning device that removes fine particles by giving them an electric charge and then collecting them on plates of opposite polarity. In a commercial kitchen it sits in the exhaust duct and takes grease, smoke and oil mist out of the airstream, so what leaves the roof is a clean, invisible discharge rather than a visible plume of cooking fume.

How does an ESP filter work?

Four stages. A pre-filter screen knocks out the coarse oil mist. The remaining droplets pass a 12 kV ionisation zone where they pick up a negative charge. They then enter a low-voltage collection zone, where the charged particles are attracted onto earthed plates. A second screen catches anything left, and the collected grease runs down the plates to a sump and out through a drain.

Which ESP filter do I need for my kitchen?

Size on cooking load first. Allow roughly 2,000–3,000 m³/h per wok burner, or 2,000–2,500 m³/h per metre of hood, and multiply by 1.5–2 for grill and fry work. Then pick the next model up in the range. Our airflow calculator does this including the duct, elbow and pressure-drop allowance, and returns the model with the margin shown.

What efficiency does an ESP filter reach?

The KL-D-J range is rated at 95% or better on grease and smoke, with an outlet concentration of 1–2 mg/m³ — low enough that the discharge is visually smoke-free. The self-cleaning KL-D-Q reaches 98%. Efficiency holds only if the cell is washed on schedule; a loaded cell looks identical from outside and quietly collects less.

Can an ESP filter be installed where there is no duct?

The cell itself needs ductwork to sit in. Where there is no duct — a mall island, a basement unit, a leased retail space — the answer is an integrated hood with the cell inside the canopy, which cleans the air and returns it to the room instead of discharging it.

Do I need a water spray stage as well?

For charcoal, solid fuel, tandoor or a heavy wok line, yes. Those loads bring sparks, ash and radiant heat that a dry cell handles badly. A water spray purifier in front cools the plume, quenches the sparks and takes out coarse grease before the ESP sees it, which lengthens the cleaning interval and removes most of the fire risk.

Next step

Send the layout. We will confirm the model.

Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.

Size it in 30 seconds Chat on WhatsApp

Typical reply within one working day · MOQ 1 unit