Note · Technology
Dry ESP: what the abbreviation changes
Two letters, one design decision with three consequences: no drain, no effluent, and no tolerance for anything sticky. Whether that is an advantage depends entirely on what is in the gas.
Short answer. Dry ESP means the collected material leaves as solid, knocked off the plates into a hopper. No water is used in the removal stage, so there is no drain, no sump and no effluent — and no mechanism for removing liquid or sticky catch.
The abbreviation turns up in tender documents more often than in conversation. A specification that says “dry ESP” is making a claim about the waste stream as much as about the technology, and that claim has knock-on effects.
Consequence one: no drain
Without water there is nothing to drain, which removes a whole category of failure — blocked spigots, grease traps that nobody empties, sumps that overflow into the duct. It also removes the only mechanism that keeps a plate clean between services.
Consequence two: no effluent
Wet designs produce a grease-and-water stream that has to go somewhere lawful. Dry designs produce a solid that can be bagged and disposed of as a trade waste. On a site with no trade-effluent consent, that difference decides the design.
Consequence three: a narrower application window
Dry collection requires the catch to be a solid at cabinet temperature. Ash, mineral dust and metal oxide fume qualify. Grease, oil mist and tar do not. Industrial plants often run a dry ESP at 150 °C or more precisely so that the catch stays dry — a trick a kitchen cannot use, because the exhaust is at 40–60 °C and the grease is already liquid.
What to ask when a quote says dry ESP
Ask what the catch is, at what temperature, and how it leaves the cabinet. If the answer is “dust, at 160 °C, by rapping into a hopper”, the design is coherent. If the answer is “grease, at 50 °C”, the design is wrong regardless of how it is described.
For kitchen work, the question is not dry versus wet but manual wash versus automatic wash; both are wet. The ESP filter pages state the wash method and interval for every model so the comparison can be made on the right axis.
The electrostatic precipitator we would put on a job like this is the KL-D-J, in whichever size the airflow calculation returns.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
