ESP filters 4,000–64,000 m³/h · CE certified · ISO 9001 · Shipping to 80+ countries

info@souniny.com / WhatsApp +86 189 2910 1713

Note · Maintenance

Electrostatic precipitator cleaning: the procedure that protects the cell

Most cell damage is caused by cleaning, not by cooking. Plates get bent, insulators get cracked and supplies get shorted by people who are trying to do the right thing quickly.

Short answer. Isolate, pull the cell, soak it in a degreaser at the recommended dilution, rinse thoroughly, dry completely, and clean the insulators and cabinet floor while it is out. Never scrub, never jet the plates directly, never re-energise wet.

The cell is a mechanical assembly of thin plates held at a precise spacing. Anything that bends a plate or shifts the spacing has changed the electrical behaviour of the whole cell, and the change is permanent.

The sequence

Isolate. At the isolator, not the control panel. The door interlock drops the high voltage, but the isolator is what the maintenance record should show and what protects the next person.

Pull. The cell slides out on rails as a cassette. Lift by the frame, never by the ionisation wires or the insulators at either end.

Soak. Degreaser at the stated dilution, 15–30 minutes. This is where the work is done; scrubbing only removes what soaking has already loosened.

Rinse. Thoroughly, both directions, until the water runs clear. Residual alkaline cleaner on a plate becomes a conductive path and the cell arcs the moment it is energised.

Dry. Air dry or a soft air line. Not a heat gun on the insulators — thermal shock cracks them.

Clean the rest. Insulators top and bottom, the earth contacts on the rails, and the cabinet floor. A perfectly clean cell in a cabinet with a greasy insulator still will not hold voltage.

Five mistakes worth naming

  • Wire brush on the plates. Bends edges, removes the surface finish and creates arc points.
  • High-pressure jet at close range. Same damage, faster.
  • Re-energising damp. Trips protection at best, tracks an insulator at worst.
  • Cleaning only the cell. The insulators and earth contacts are half the electrical circuit.
  • No record. Without dates, nobody can tell whether the interval is right for the load.

How often

7–14 days on a wok or charcoal line, 14–30 days on fryers and grills, monthly on ovens and induction. The interval follows the cooking, not the calendar, and it is worth checking against the panel voltage after each wash.

Where the interval will not be honoured, the self-cleaning version does it in place on a 1–15 day cycle. Both are on the electrostatic precipitator range page, with the wash method stated per model.

None of it is exotic: it is the standard build of an ESP filter, and the specification sheet on the front page lists every model and pressure drop.

Next step

Send the layout. We will confirm the model.

Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.

Size it in 30 seconds Chat on WhatsApp

Typical reply within one working day · MOQ 1 unit