ESP filters 4,000–64,000 m³/h · CE certified · ISO 9001 · Shipping to 80+ countries

info@souniny.com / WhatsApp +86 189 2910 1713

Note · Maintenance

Electrostatic precipitator detergent: the specification, not the brand

Detergent choice is usually made by whoever is standing in the cash-and-carry. It is a specification problem with four requirements, and any product that meets them will work.

Short answer. The detergent has to saponify animal and vegetable fat at 40–60 °C, rinse to a non-conductive residue, be safe on stainless and aluminium, and be disposable through the grease trap. Anything that meets those four is suitable.

Requirement one: it must work on fat

Cooking grease is mostly triglycerides, and alkaline chemistry is what breaks them down. A neutral pH “multi-surface cleaner” will wet the surface and do very little else. Look for an alkaline builder, typically sodium hydroxide or a silicate-buffered system.

Requirement two: it must rinse clean

This is the requirement that matters electrically. Any film left on a plate is a leakage path, and a cell that arcs after washing is a cell with residue on it. Products marketed as “no-rinse” are for floors, not for precipitator plates.

Requirement three: compatible with the metals

Stainless plates tolerate caustic well. Aluminium components do not: strong caustic attacks aluminium quickly, which is why some cells specify a milder product. Check what the cell is made of before choosing the strongest cleaner on the shelf.

Requirement four: disposable

Wash water goes to the grease trap, not to surface water. A detergent that emulsifies grease permanently passes it through the trap and into the drain run, which is a different and more expensive problem.

A simple test

Wash one cell with a candidate product, dry it fully, energise it and compare the panel voltage with the reading you get after your current routine. If it is higher and stable, the product is better; if it arcs, the rinse was short or the chemistry is wrong. Two washes will tell you more than any data sheet.

What we recommend

A buffered alkaline degreaser at 2–5% at 50 °C, 20 minutes soak, two rinse passes. Every electrostatic precipitator cabinet we ship carries that recommendation on the inside of the access door, because it is the one piece of maintenance information that gets read at the right moment.

Start from the electrostatic precipitator overview if you need the whole range in one view, then narrow to the model from the airflow.

Next step

Send the layout. We will confirm the model.

Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.

Size it in 30 seconds Chat on WhatsApp

Typical reply within one working day · MOQ 1 unit