Note · Technology
Electrostatic precipitators: how the family splits
The plural matters. Ask five suppliers for an electrostatic precipitator and you may get five different machines that all meet the definition and none of which are interchangeable. The differences are worth ten minutes.
Short answer. The family splits by plate geometry (flat plate or tubular), by removal method (dry rap or wet wash), and by field arrangement (single-stage or two-stage). Commercial kitchens use flat-plate, two-stage, wet-washed cabinets almost exclusively.
Every member of the family does the same two things: charge particles and collect them. What changes is how the collection surface is shaped, how it is cleaned, and how many fields the gas passes through before it leaves.
Flat plate versus tubular
Flat plate is the industrial default and the kitchen default. Parallel plates, gas flowing horizontally between them, dust or grease falling to a hopper or sump. It is cheap per square metre of collection area and easy to inspect.
Tubular puts the collecting surface inside a cylinder with the discharge electrode on the axis. It handles higher pressure and wet operation better, and it is what you find in wet precipitators on saturated gas. It is also far harder to clean by hand, which rules it out for kitchens.
Dry versus wet
Dry precipitators rap the plates and drop the catch into a hopper: right for fly ash, wrong for grease. Grease does not fall when you tap it; it smears, carbonises and eventually bridges the gap. Wet precipitators keep a film of water running over the plates so the catch is carried away continuously. The kitchen cabinet is a wet design in effect — the wash is intermittent rather than continuous, but the removal principle is the same.
Single-stage versus two-stage
Single-stage combines ionisation and collection in one field: the same plates that create the corona collect the particles. Industrial plant works this way. Two-stage separates them — a dedicated ioniser section followed by a plate section — which allows a higher collecting voltage without arcing and gives better efficiency on fine aerosol at small spacing.
Every commercial kitchen cabinet worth the name is two-stage with 7.5 mm plate pitch. When a data sheet does not say which arrangement it is, that is usually the answer.
What the split means when buying
- Ask for the arrangement — two-stage or single. It predicts efficiency on fine grease better than the headline percentage.
- Ask for plate area in m². Two cabinets of the same airflow with different plate area are not the same product.
- Ask how it is cleaned and at what interval, at your cooking load. That answer decides the five-year cost.
All seven families on the ESP filter page are flat-plate two-stage designs, because that is the architecture that survives a kitchen. The industrial variants exist in the catalogue; they are simply not what a restaurant should be specifying.
What separates a kitchen ESP that lasts from one that does not is usually the wash regime, and that is a site decision, not a factory one.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
