ESP filters 4,000–64,000 m³/h · CE certified · ISO 9001 · Shipping to 80+ countries

info@souniny.com / WhatsApp +86 189 2910 1713

Note · Technology

How do electrostatic precipitators work?

There is a mechanical answer and an operational one. The mechanical answer is charging and collecting. The operational answer is that the device only works while its plates are clean, its insulators are dry and its drain is open — and that is where most of the engineering effort actually goes.

Short answer. Airborne particles are charged by a high-voltage corona, pushed sideways by an electric field onto earthed plates, and then removed as liquid through a drain, or as dry dust by rapping. Efficiency depends on field strength and on how clean the plates are.

The whole device fits in a single sentence: charge it, catch it, get rid of it. Everything that goes wrong in service is a failure of the third clause. A cell that will not hold voltage has usually stopped getting rid of what it caught, not stopped catching.

Stage one: ionisation

Between the ioniser wire and the earthed frame there is a field gradient steep enough to ionise air. The electrons released attach to oxygen and water molecules within microseconds, and those ions — not the electrons — are what charge the grease droplets. This is why humidity changes the electrical behaviour of a cell without changing its geometry, and why a wet cell trips a supply that was fine dry.

Around 12 kV is the working figure in a kitchen cabinet. Industrial plant runs higher, because the gap is larger and the gas is hotter.

Stage two: collection

The charged droplet enters the plate stack and drifts sideways under the field. Drift velocity is small — a few centimetres per second at most — so the plates have to be long enough and close enough for the particle to reach a surface before it exits. That is the whole reason a precipitator is a cabinet rather than a section of duct: it needs residence time.

Particles that are too small to charge well, or too light to settle, pass through. That fraction is what the 95–98% figure leaves behind, and it is why the outlet reads 1–2 mg/m³ rather than zero.

Stage three: removal

Two philosophies. Industrial plant raps the plates with hammers on a timer and drops the dust into a hopper, dry. Kitchen cabinets wash: either the operator pulls the cell and hoses it, or a self-cleaning unit sprays it in place on a 1–15 day cycle. Wet removal is messier and far more reliable, because grease does not fall off a plate when you tap it — it sits there and carbonises.

On a charcoal grill or a wok line the load is heavy enough that a manual cell wants washing every 7–14 days. Miss two cycles and the unit is still running, still drawing current, and quietly collecting half of what it did when it was clean.

What the four stages mean for the buyer

Two consequences follow, and both show up at quotation time. First, the fan has to be sized for a loaded cell, not a clean one, which is why the 20% margin in the airflow calculation exists. Second, the cabinet needs service access: a cell that is awkward to remove gets removed late.

A kitchen ESP that is engineered around those two facts costs more to build and less to own. That trade is the whole argument for specifying by wash interval rather than by purchase price.

Everything described here is what gets built into a kitchen ESP before it leaves the factory — the cell, the drain, the interlock, the fan curve.

Next step

Send the layout. We will confirm the model.

Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.

Size it in 30 seconds Chat on WhatsApp

Typical reply within one working day · MOQ 1 unit