Note · Kitchen
Kitchen exhaust filtration: the ladder from baffle to carbon
Filtration is sold as a single decision and is really a ladder. Each stage removes a different fraction, and the right place to stop depends on what is cooking and who is standing outside.
Short answer. The ladder is baffle, mesh or cyclone, electrostatic cell, then carbon. Baffle catches coarse grease, the cell catches fine aerosol and smoke, carbon catches odour. Each stage costs more to buy and less to ignore than the one below it.
Two rules govern the whole ladder. Cheaper stages go first, because they are cheaper to clean. And each stage protects the one after it, so skipping a low rung does not save money — it moves the cost into the expensive stage's maintenance.
Rung one: baffle
Removes the coarse droplets that would otherwise load everything downstream. Cheap, washable, and required in most canopies anyway. Removes almost none of the visible plume.
Rung two: mesh or cyclone
Finer droplets, flame and embers. A cyclone is worth its pressure loss on a charcoal line where ash is present; mesh is enough on a fryer line.
Rung three: electrostatic cell
The stage that changes the result. 95–98% of the remaining aerosol, including the sub-micron fraction that makes smoke visible. This is the rung most kitchens with a complaint should be standing on.
Rung four: carbon
Odour. Bonded or granular carbon behind the cell, sized on residence time rather than on airflow alone, because a thin bed at high velocity removes almost nothing. Replaced on a schedule that depends on loading, not on a calendar guess.
Where to stop
Three questions: is there a visible plume? Is there an odour complaint? Is there a planning condition? Visible plume only — stop at rung three. Odour as well — rung four. Neither, and a baffle is honest.
The fourth rung is where budgets usually break, and the good news is that it can be added later: a cell installed now can have a carbon stack bolted on when the neighbour complains, which is cheaper than buying both at once on a guess.
Stage three is the one we build, in sizes from 4,000 to 64,000 m³/h, and the ESP filter range states the outlet concentration per model rather than a single figure for the family.
If you would rather see the hardware than read about it, the ESP purifier range on the front page covers 4,000 to 64,000 m³/h in one family.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
