ESP filters 4,000–64,000 m³/h · CE certified · ISO 9001 · Shipping to 80+ countries

info@souniny.com / WhatsApp +86 189 2910 1713

Note · Technology

Passive filtration: what it does before the ESP

Passive filtration is the cheapest thing in the exhaust line and the most often skipped. It removes the fraction that would otherwise foul the expensive equipment downstream, and it does it with no electricity, no controls and no service contract.

Short answer. Passive filtration removes coarse droplets and flame by changing the direction or speed of the air — baffles, mesh, cyclones, settling chambers. It handles the large end of the grease spectrum and nothing below a few micrometres, so it protects a precipitator rather than replacing it.

The distinction is mechanical, not marketing: passive devices have no power supply and no moving parts. Air is forced to turn, and the droplets it carries keep going straight until they hit something.

The four passive stages

  • Baffle. Angled vanes that force the airstream through two or three sharp turns. Cheap, effective on droplets above about 20 micrometres, and the default first stage in a canopy.
  • Mesh. Layered wire or expanded metal. Catches finer droplets and flame, but blinds quickly on a heavy load and needs degreasing on the same rhythm as the cell.
  • Cyclonic. Spins the air so droplets are thrown to the wall. Good on high loading, higher pressure loss, used where the duct run allows the height.
  • Settling. A sudden expansion that slows the air so heavy droplets fall out. Rarely used alone; occasionally the first chamber in a large plenum.

What passive stages cannot do

They do not touch the fine fraction. The sub-5-micrometre droplets that make a plume visible and a roof stained pass through a baffle almost untouched, because their inertia is too low to carry them into a vane. That fraction is what an electrostatic stage exists for.

This is why “we already have baffle filters” is not an answer to an emission complaint, and why a project that removes baffles to fit a bigger cell usually regrets it — the cell then eats the coarse load and needs washing twice as often.

Where the boundary sits

Rule of thumb: passive for the top 10–20% of the mass, electrostatic for the rest. A well-designed line runs baffle, then mesh, then ioniser, then cell. Each stage is cheaper to clean than the one after it, and the order is deliberate.

On a charcoal grill the sequence often gains a water stage as well, because embers and ash are abrasive and a wet wall is the cheapest way to stop them. The full ladder is set out on the kitchen ESP page, with the pressure budget each stage adds.

If you would rather see the hardware than read about it, the ESP purifier range on the front page covers 4,000 to 64,000 m³/h in one family.

Next step

Send the layout. We will confirm the model.

Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.

Size it in 30 seconds Chat on WhatsApp

Typical reply within one working day · MOQ 1 unit