Note · Technology
Where are electrostatic precipitators used? Eight places you can see one
Nobody points at a restaurant roof and says “there is a precipitator”. But the technology is in the building services of half the buildings you walk past, doing a job that has no visible output when it works.
Short answer. Power stations, cement plants, steel works, waste incinerators, commercial kitchens, food factories, welding shops and some large HVAC systems. Anywhere fine particulate has to come out of a gas stream at a scale where media would be too expensive to keep replacing.
1. Power stations
The classic application, and the reason the technology exists commercially. Fly ash from coal or biomass, removed before the stack, often with a wet flue-gas desulphurisation stage downstream.
2. Cement and lime plants
Kiln dust at high temperature. The precipitator is usually the largest single piece of air equipment on site and runs continuously for years between major overhauls.
3. Steel works and foundries
Melting fume, often with a secondary hood system. Frequently paired with a bag filter, with the precipitator taking the coarse load so the bags last.
4. Waste incinerators
Fine particulate and metal fume, usually as part of a multi-stage train with acid gas scrubbing and carbon injection.
5. Commercial kitchens
The version this site is about. Above a wok range, in the extract duct or on the roof, removing the grease aerosol that would otherwise coat the duct and stain the building. Sizes from 4,000 to 64,000 m³/h.
6. Food factories
Fryer lines, smokehouses, rendering. High grease loading, often saturated gas, and hygiene rules that make media unattractive.
7. Workshops
Welding fume extraction and machining oil mist. Small units, continuous duty, washed rather than replaced.
8. Large HVAC systems
Electronic air cleaners in commercial air handling, sold on indoor air quality. Lower loading, smaller cells, and the same maintenance obligation.
What they have in common
Every one of those eight sits where the particle is fine, the loading is continuous, and the alternative is a consumable with a permanent cost. That is the entire commercial case for the technology, and it is why it survives alongside filters that are, in many other respects, simpler.
The kitchen examples in this list are the ESP filter range: seven families, one cell design, and a specification table that gives airflow and pressure drop per model.
If you would rather see the hardware than read about it, the ESP purifier range on the front page covers 4,000 to 64,000 m³/h in one family.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
