Guides
ESP selection, installation and maintenance guides — page 2
Notes written from site work: what decides a model, what actually causes efficiency to fall, and which specification mistakes are expensive to fix after commissioning.
- Sizing and duct pressure
- Cleaning intervals that hold
- Odour, carbon and stage order
- Inspection and compliance
Precipitator inspection: what an inspector actually looks at
Six documents and four physical checks — most failures are paperwork, not hardware.
ESP maintenance: in-house, contractor, or automatic
The cheapest option depends on who is on site at 11pm on a Friday.
Precipitator maintenance: the one-page checklist
Ten checks a kitchen supervisor can actually do, in the order they should be done.
Electrostatic precipitator maintenance: the twelve-month programme
Four intervals, twelve checks, and the one item that is never on the list.
Electrostatic precipitator detergent: the specification, not the brand
Four requirements, one test, and the reason residue is worse than grease.
ESP cleaner: what to use, and what will ruin the cell
Chemistry matters less than rinsing — but four products will still destroy a cell.
ESP cleaning: how often, really
Intervals by cooking type, and the four signals that should override the schedule.
Electrostatic precipitator cleaning: the procedure that protects the cell
Soak, don't scrub. Rinse, don't rush. And never re-energise a wet cell.
Bonded carbon filters: what the binder changes
Rigid, uniform and easy to change — with a real trade in capacity and dwell time.
Carbon filtered enclosure: odour control as a box, not a bolt-on
One enclosure, two stages, no leaks between them — and a bed sized on dwell time.
Where are electrostatic precipitators used? Eight places you can see one
The technology is invisible until you know where to look — eight everyday locations.
Electrostatic precipitator applications: a map by industry
Seven industries, one principle, seven different reasons for choosing it.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
