Guides
ESP selection, installation and maintenance guides — page 5
Notes written from site work: what decides a model, what actually causes efficiency to fall, and which specification mistakes are expensive to fix after commissioning.
- Sizing and duct pressure
- Cleaning intervals that hold
- Odour, carbon and stage order
- Inspection and compliance
Precipitator: the one-word version
Site shorthand, decoded: the four machines called "the precipitator" and how to tell them apart.
Electrostatic precipitators: how the family splits
One principle, five architectures — and the one that suits a commercial kitchen.
How does an electrostatic precipitator work? Minute by minute
One puff of wok smoke, tracked from the hood face to the discharge point.
What do electrostatic precipitators do? Removal, not magic
What goes, what stays, and the single number that tells you whether it is working.
The electrostatic precipitator process, stage by stage
The cell is stage four of five. Most of the failures happen in one and five.
Electrostatic precipitator diagram: every part, labelled
Read the drawing from the dirty end to the clean end, and every other decision follows.
Definition of electrostatic precipitator, plainly put
One definition, four exclusions, and why the edges of the term matter when you are writing a spec.
Precipitator meaning: what the word actually means
From Latin praecipitare, to throw down: the word describes the fall, not the charge.
Electrostatic precipitation: the physics behind the box
Cottrell, corona discharge and drift velocity: the three ideas that make the cabinet possible.
How do electrostatic precipitators work?
Four stages, and the one that quietly determines whether the other three keep working.
What is an electrostatic precipitator?
One sentence, four parts, and the three things people assume it does that it does not.
Electrostatic precipitator: what is actually inside the box
Five parts, one job: charge the grease, collect it, and get it out of the cabinet without arcing.
Next step
Send the layout. We will confirm the model.
Appliance list, hood length and the duct route are enough to come back with a model, an airflow figure and a drawing. OEM and ODM enquiries welcome.
